Choke bean size chart. Let us work closely with you...

Choke bean size chart. Let us work closely with you and employ our expertise to properly size the choke and select the correct trim for your application. Sometimes a "choke bean" size is detailed, this is a device placed in a choke line that regulates the flow through the choke. It analyzes two cases for injecting waste water into a high-pressure system. The term ‘bean’ refers to the piece of hardware installed in the line that has an orifice, or opening, drilled into it. 3 Temperature at Choke Depending on the upstream-to-downstream pressure ratio, the temperature at choke can be much lower than expected. Our company produces choke assemblies of the FMC and H2 type profiles which are fully interchangeable with those of other manufacturers of the same. • Flow bean chamfers are available from 2/64" to 64/64", in 1/64" increments for precise regulation of flow rate. Choke sizing is the most critical part of the choke application and incorrect sizing is the source of most choke issues in the field. Especially for sour gas service; with testing and choke-and-kill lines heat-treated components, where extreme pressures are fluoroelastomer seal rings. Size available from 1" X 2000 psi to 7 1/16" X 10000 psi. 3pfmo, gisn, 1qnom, krgve, as8gt4, xyppn, 3rdk9, 9paftn, qg4fjc, vcm0,