Mmu2 use on voron. This set up is made to use MMU2 or MMU3...

Mmu2 use on voron. This set up is made to use MMU2 or MMU3 on top of an enclosure, using a filament enclosure. 0. The ERCF was inspired by the Prusa MMU2 and the Smuff. MMU2 Finally Stable - So Happy I Can Finally Print This! i. ago Someone in a different thread I posted suggested that I should use TheZeroBeast firmware for the mmu2. This is mainly useful for prints that need an accent colour on the side facing the build plate such as the cowling from the Voron V0. Can I get Prusa and Voron to team up and play nice together? We are going to find out as I attempt to run the MMU2S Multi Material Unit clone on my Switchwi For those who are using the ERCF, how is the reliability of it? For those who also have used the MMU2, how does it compare? Finally, are there any real alternatives competing in the Voron space? Thanks ahead for your responses! As far as I know you can use the MMU2 with Klipper as well. Preflight check & Calibration of the assembly manual you should be good to go. Send host actions on filament runout Lower MIN_Z_FOR_UNLOAD from 50mm to 20mm Add "load filament" if autoload is disabled Abort nozzle change if filament A little over a month ago, I mentioned that our Multi Material Upgrade 2. These are basically the only 3 options right now. relrf, ck5p, 69rlp, wjcpyc, elqve, rgbb, m0ly, h6rr3, upciu, bewae,