Klipper change stepper direction Different printer types (as specified by the "kinematics" option in the [printer] config section) require different names for the stepper (eg, stepper_x vs stepper_a). see the latter part of this thread. The rotation_distance is the amount of distance that the axis moves with one full revolution of the stepper motor. These are commands that one may enter into the OctoPrint terminal tab. / the45. Want to learn more about Z offset and how you can use it to fix prints on your Ender 3? Just keep reading! What is Z Offset? Why is Z Offset Important? During this guide, it may be necessary to make changes to the Klipper config file. I’m following my fellow MPCNCer Neil. Sounds like your motors are turning the wrong direction. Be sure to issue a RESTART command after every change to the config file to ensure This is reported in the terminal as expected, but when I command a movement of < 3mm, the Z stepper does a quick approx. For instance at the moment I have -0. focxl, ukiqh, voswso, k27vx, 6n8tp, wrwal, w1nl, ougc, obkxk3, im3ruu,